Wintermute User Guide

If you've spend any time with this documentation, you should have a sense of how most things can be achieved by shuttling commands back and forth between Wintermute and Qlab. So far so good! Macros may seem fiddly, but once you've got the hang of them, they will make many tasks easier - think of them as mini cue lists that run within Wintermute.

Here's the basics:

• Macros are lists of Wintermute commands and parser directives
• Each command or directive can have an associated delay time in milliseconds
• For commands with the same delay time, they are executed in the order they are added
• Each macro has a trigger and a name - it is referred to by the trigger if the name is blank.
• Macros are associated with a Node¹⁾
• There are three types:
  • Network Node Macros that are run when receiving the relavant trigger from a networked node
  • Midi In Macros that are run from a corresponding midi_trigger. These macros must have a name as you can't refer directly to the trigger.
  • Streamdeck Macros that are triggered by a key up or key down from an attached Streamdeck
• The only limit on execution and length is an overrun counter - if you try and run more than 128 commands from a single macro without a delay, the parser will assume that you've accidently created an infinte loop and halt the macro - this will be flagged in the system log.
• Each macro has it's own private set of variables that allow you to pass parameters to the macro - this is particularly important when deploying the same macro to multiple nodes.